What should be paid attention to when installing a long floor drain in the bathroom:

1. Before installing the long floor drain in the bathroom, the floor drain core must be removed, so as to prevent debris from falling into the floor drain core and causing damage.

2. The purpose of installing the long floor drain is for drainage, so the installation position of the long floor drain should be slightly lower than the ground to facilitate drainage. Before the floor drain is installed, if the drainpipe is too close to the ground, the drainpipe should be cut appropriately, so as to ensure that the panel of the installed floor drain is slightly lower than the ground.

3. In order to ensure that the overall decoration effect is not destroyed, the installation position of the long floor drain in the bathroom should not be too much lower than the ground. Therefore, if the drainage pipe is too far from the ground, it should be filled with cement mortar, which can achieve the purpose of raising the drainage pipe. , Only after the floor drain is installed can a good decorative effect be guaranteed.

4. When installing a long floor drain in the bathroom, in order to prevent tools and other items from falling into the drainpipe and causing the blockage, block the drainpipe with a cloth or other soft items in advance, and take it out when the floor drain core is installed.

5. The installation of the long floor drain in the bathroom should take into account the convenience of future maintenance. Therefore, when filling cement mortar, the floor drain should not be used directly, but kraft paper or other strong materials should be rolled into a cylinder that matches the sewer pipe and docked with the sewer pipe. , and raised above the ground, and then filled with cement mortar.

6. The long floor drain is docked with the sewer pipe and is higher than the ground. Fill the mixed cement mortar (1:1) into the surrounding space, adjust the height of the floor drain panel to an appropriate position, and wait for the cement mortar to solidify. Put it into the pipe it forms so that it fits snugly against the pipe wall.